![[第2年] 级别:1](https://static.trustexporter.com/skin/default/image/vip_1.gif)
Steel tape armoured mainly as the radial mechanical protection layer of the cable, and it also have additional total shielding effect, especially steel tape armoured and copper wire, copper tape screened, is to use two different shielding materials, on the electromagnetic shielding of going about with each other, the shielding effect will be better.
使用条件1：使用温度（℃):-40～+602:相对温度:40℃时达98%3:安装敷设温度不低如:-15℃4:充许最小弯曲半径:室内不小于5倍,室外10倍结构1:镀锡铜丝线芯2:聚氯乙烯绝缘3:薄膜绕包4聚氯乙烯护套额定电压:300V/300V 300V/500V采用标准:GB/T。
1. Purpose: this product is used for connecting electrical appliances and meters in power distribution devices with rated ac voltage of 500V or dc voltage of 1000V or below. 2, product characteristics: cable conductor of long term working temperature should be allowed no more than 70 ℃. When the cable temperature under installation should not below 0 ℃, when laying bending radius should not less than 10 times of cable diameter. The cable with armor layer or copper band shielding structure shall not be less than 12 times the outer diameter of the cable. 3. Product standard: gb9330.2-88 PVC insulated and sheathed control cable
--铜芯、聚烯烃绝缘、聚氯乙烯护套市内通信电缆。使用温度均为-30度~60度。HYA通信电缆，HYA22HYA23铠装通信电缆。用途：实心绝缘填充型电缆适用于本地电信网的城市与乡镇电信线路，也适用于接入公用网的专用网线路。
ZR-BPYJVP交联聚乙烯绝缘聚氯乙烯护套铜丝编织屏蔽变频电力电缆。ZR-BPYJVP2交联聚乙烯绝缘聚氯乙烯护套铜带绕包屏蔽变频电力电缆。ZR-BPYJVPP2交联聚乙烯绝缘聚氯乙烯护套铜丝编织铜带绕包屏蔽变频电力电缆。
相邻两盘、柜、台接缝处正面的平面度允许偏差为(1mm)。3(四氟填料)使用寿命短，在极限温度下只能用到3-5个月。3双法兰式差压变送器毛细管的敷设应有(防护措施)，其弯曲半径应小于(50mm)，周围温度变化剧烈时应采取隔热措施。3执行机构的(机械传动)应灵活，无松动和卡涩现象。3当线路周围环境温度超过65℃时，应采取(隔热措施)；当线路附近有火源时，应采取(防火措施)。3线路进入室外的盘、柜、箱时，宜从(底部)进入，并应有(防水密封)措施。
控制电缆泛指设备仪表供电/信号控制。代表型号：KVV/KYJV/还有其它仪表线等等产品说明:执行标准：GB/T。阻燃电缆还应符合IEC337-8标准的技术条件。尤其适用于消防与保安系统保护回路的控制及动力的传输线。
型号：ZRC-HYAT阻燃通信电缆，WDZ-HYAT无卤阻燃通信电缆，ZR-HYAT阻燃通信电缆，MHYAT矿用通信电缆技术特点：防火阻燃低损耗低色散结构紧凑良好的综合机械性能应用范围：适用于矿山、电厂、市内、近郊及局部地区，起到防火阻燃作用。
Main characteristics of the mine cable fire with fire temperature in 600 ℃ ~ 8000 ℃, the fire cases, the cable will soon lose insulating ability, thus cause the secondary electrical accidents such as short circuit, causing a greater loss. The wire and cable have greater overload capacity under the specified allowable load flow. In a short circuit, the wire and cable will instantly cause the insulation to melt and ignite the surrounding area.
1. Purpose: this product is used for connecting electrical appliances and meters in power distribution devices with rated ac voltage of 500V or dc voltage of 1000V or below. 2, product characteristics: cable conductor of long term working temperature should be allowed no more than 70 ℃. When the cable temperature under installation should not below 0 ℃, when laying bending radius should not less than 10 times of cable diameter. The cable with armor layer or copper band shielding structure shall not be less than 12 times the outer diameter of the cable. 3. Product standard: gb9330.2-88 PVC insulated and sheathed control cable
全国电线电缆行业又有了良好的市场机遇，各地电线电缆企业抓住机遇，迎接新一轮城乡电网建设与改造2012年9月26日，由印度尼西亚电线电缆协会、马来西亚电线电缆协会、越南电线电缆协会以及台湾地区电线电缆行业公会等6个行业组织构成的"亚洲电线电缆行业组织（AWCCA）"在上缆正式成立。
但是在电缆燃烧时会释放大量的浓烟和卤酸气体，卤酸气体对周围的电气设备有腐蚀性危害需要带上防毒面具才能接近现场进行灭火。电缆燃烧时给周围电气设备以及救援人员造成危害，不利于灭火救援工作，从而导致严重的“二次危害”。
PM型步进电机价格低是其一大优势。定子与转子之间气隙约为0.25mm，轴承使用滑动轴承（sleevemetal)，PM型步进电机的构造如下剖视图所示。当有特殊需求时，可采用下左图的悬臂结构形式。上右图为其外观。此电机厚度为14mm，外径68mm，呈扁平状，转子有100极，步距角为1.8°。此种结构的转子轴插入轴承时，能确保定子内径与转子外径间的气隙是固定的。滑动轴承有金属系列与树脂系列，金属系列有铁系含油轴承或铜系含油轴承。
CPEV-SCPEV-S通信电缆|CPEV-S|CPEV-S电缆CPEV-S绞式聚乙烯绝缘聚氯乙烯护套市内通信电缆市内通信电缆数字巡回检测装置用屏蔽电缆KJCPKJCPR地面通信电缆（地面通信线缆）HYA执行YD/T标准-产品介绍-市内通信电缆|市话通信电缆|通信电缆HYA|充油通信电缆HYAT|。
由于其成本较低，因此是防火电缆中大量采用的电缆品种。无论是单根线缆还是成束敷设的条件下，电缆知燃烧时能将火焰的蔓延控制在一定范围内，因此可以避免着火延燃而造成的重大灾害，从而提高电缆线路的防火水平。耐火电缆是在火焰燃烧情况下能保持一定时间的正常运行，可保持线路的完整性。
MHYVP矿用聚乙烯绝缘、阻燃聚氯乙烯护套、铜丝编织屏蔽信号电缆1-101/1.38用于井下干扰较大的场合。MHYV31矿用聚乙烯绝缘、阻燃聚氯乙烯护套、镀锌钢丝编织铠装信号电缆1-201/1.00用于井下平巷作主信号干线电缆。
This is the flame retardant standard for bundles of cables. According to the test regulations, the 3.5m long cable samples are fixed with iron wire on the trapezoid test frame, and the number of samples is determined according to the different classification requirements of non-metallic materials. The sample is hung vertically on the back wall of the furnace, and air is introduced into the furnace through the inlet on the bottom plate.