本系列产品采用纯正的台湾技术制造,无论是机型结构,变压控制系统,加压力学结构,触发方式,还是主机器的设计制造,都拥有完整的制造技术,经历了无数用户的反复检验。焊机的每一个细节设计皆精益求精。本机主要气动元件均采用日本时进口,气缸运动部位异常灵活,无虚位产生,焊机变压器产用进口硅钢片,次级铸铜精加工,内部强制通水冷却,功率输出强劲,使用寿命长,故障率极低。
This series of products using pure Taiwanese technology manufacturing, whether it is the model structure, transformer control system, pressing the mechanical structure, trigger mode, or the host device design and manufacturing, have complete manufacturing technology, we have experienced repeatedly tested countless users . Every detail of the design are better welder. This machine pneumatic components are imported from Japan, the cylinder moving parts very flexible, no dummy bit generation, welding transformer production with imported silicon steel, bronze finishing secondary internal forced water cooling, power output strong, life long, very low failure rate.
本产品为交流熔接焊机,控制系统能满足客户随意调节。双电流,双开关,不用调节可在一台机上完成两种产品的焊接。
This product is for the exchange of weld welder, precise control of the system can be adjusted to meet customer. Double the current, double switch, without adjustment to be completed by welding the two products on a single machine.
本产品速度极快,生产效率高,用在铁线网类制品更能体现其快速,稳定的特点。
This product is fast, high production efficiency, used in wire mesh products to better reflect its rapid and stable characteristics.
以下是几种不同额定功率的主要技术参数:
The following are the main technical parameters of several different power ratings:
额定功率rated power | 电源电压voltage | 相数Phase | 次级空载电压Secondary no-load voltage | 暂载率Duty rates |
53KVA | 380V50HZ | 2 | 约6.0 | 25% |
63KVA | 380V50HZ | 2 | 约8.0 | 25% |
83KVA | 380V50HZ | 2 | 约10 | 25% |
103KVA | 380V50HZ | 2 | 约12 | 25% |
最大臂伸出长度The maximum arm extension length | 电极行程Electrode stroke | 额定最大焊接能力(铁线)Rated maximum welding capacity (wire) | 备注Remark | |
300-600mm | 40-50mm | 6+6mm | 气动双调节Pneumatic double adjustment | |
300-1500mm | 40-50mm | 8+8mm | 气动双调节Pneumatic double adjustment | |
300-1500mm | 40-50mm | 10+10mm | 气动双调节Pneumatic double adjustment | |
300-1500mm | 40-50mm | 15+15mm | 气动双调节Pneumatic double adjustment |